Eletrólise da Água

Decomposição da água em gases hidrogênio e oxigênio

Electrochemistry Intermediate (High School) 40 min ~$15,00

Objetivo

Decompor a água em gases hidrogênio e oxigênio usando eletrólise, e verificar a razão de volume 2:1 prevista pela estequiometria.

Contexto

Water electrolysis uses electrical energy to drive the non-spontaneous decomposition of water. At the cathode, water is reduced to hydrogen gas; at the anode, water is oxidized to oxygen gas. A small amount of electrolyte (sulfuric acid or sodium sulfate) is added to increase conductivity.

Avisos de segurança

  • Hydrogen gas is flammable — no open flames nearby
  • Do not use excessive voltage (above 12V)
  • Ensure proper ventilation

EPI necessário

goggles lab_coat

Materiais

  • Distilled water (500 mL)
  • Sodium sulfate (Na₂SO₄) (5 g)
    Electrolyte
  • Universal indicator (5 mL)
    Optional, to show pH changes

Equipamentos

9V battery or DC power supply Two graphite or platinum electrodes Two inverted graduated cylinders or test tubes Beaker (600 mL) Wires with alligator clips Stand and clamps

Procedimento

1

Dissolve 5 g of sodium sulfate in 500 mL of distilled water in the beaker.

3 min
2

Fill two graduated cylinders completely with the solution and invert them over the electrodes in the beaker.

5 min
3

Connect the electrodes to the DC power supply or battery. Note which electrode is connected to positive (anode) and negative (cathode).

3 min
4

Turn on the power supply and observe gas bubbles forming at both electrodes.

2 min
5

Collect gas in the inverted cylinders for 15-20 minutes, recording the volume at each electrode every 5 minutes.

20 min Keep flames away — hydrogen is flammable
6

Compare the volumes of gas collected. The cathode (H₂) should collect twice the volume of the anode (O₂).

3 min
7

Optionally, test the cathode gas with a lit splint (squeaky pop test for H₂) and the anode gas with a glowing splint (relights for O₂).

3 min Use small quantities for gas tests

Resultados esperados

The cathode should collect approximately twice the volume of gas as the anode, confirming the 2:1 ratio of H₂ to O₂. If universal indicator is added, the solution near the cathode turns blue/purple (basic) and near the anode turns red/orange (acidic).

Limpeza

Disconnect the power supply. Dispose of the solution down the drain. Rinse and dry the electrodes.

Detalhes

Categoria
Electrochemistry
Dificuldade
Intermediate (High School)
Duração
40 min
Custo estimado
$15,00
Passos
7
Materiais
3

Mais experimentos

Bateria de Limão 20 min Célula de Concentração 45 min Construção da Célula de Daniell 45 min Eletrólise do Sulfato de Cobre 50 min Galvanoplastia com Cobre 60 min Medição do Potencial de Célula Voltaica 60 min Métodos de Prevenção de Ferrugem 30 min Verificação da Série de Atividade 30 min

Frequently Asked Questions

What is the objective of Eletrólise da Água?
Decompor a água em gases hidrogênio e oxigênio usando eletrólise, e verificar a razão de volume 2:1 prevista pela estequiometria.
How difficult is Eletrólise da Água?
This experiment is rated as Intermediate (High School). It takes approximately 40 minutes to complete.
What safety precautions are needed for Eletrólise da Água?
Key safety precautions include: Hydrogen gas is flammable — no open flames nearby; Do not use excessive voltage (above 12V); Ensure proper ventilation.
What materials are needed for Eletrólise da Água?
The main materials required are: Distilled water, Sodium sulfate (Na₂SO₄), Universal indicator.
What results should I expect from Eletrólise da Água?
The cathode should collect approximately twice the volume of gas as the anode, confirming the 2:1 ratio of H₂ to O₂. If universal indicator is added, the solution near the cathode turns blue/purple (basic) and near the anode turns red/orange (acidic).