Electrólisis del Agua

Descomposición del agua en gases hidrógeno y oxígeno

Electrochemistry Intermediate (High School) 40 min ~$15,00

Objetivo

Descomponer el agua en gases hidrógeno y oxígeno mediante electrólisis, y verificar la relación de volumen 2:1 predicha por la estequiometría.

Antecedentes

Water electrolysis uses electrical energy to drive the non-spontaneous decomposition of water. At the cathode, water is reduced to hydrogen gas; at the anode, water is oxidized to oxygen gas. A small amount of electrolyte (sulfuric acid or sodium sulfate) is added to increase conductivity.

Advertencias de seguridad

  • Hydrogen gas is flammable — no open flames nearby
  • Do not use excessive voltage (above 12V)
  • Ensure proper ventilation

EPP requerido

goggles lab_coat

Materiales

  • Distilled water (500 mL)
  • Sodium sulfate (Na₂SO₄) (5 g)
    Electrolyte
  • Universal indicator (5 mL)
    Optional, to show pH changes

Equipamiento

9V battery or DC power supply Two graphite or platinum electrodes Two inverted graduated cylinders or test tubes Beaker (600 mL) Wires with alligator clips Stand and clamps

Procedimiento

1

Dissolve 5 g of sodium sulfate in 500 mL of distilled water in the beaker.

3 min
2

Fill two graduated cylinders completely with the solution and invert them over the electrodes in the beaker.

5 min
3

Connect the electrodes to the DC power supply or battery. Note which electrode is connected to positive (anode) and negative (cathode).

3 min
4

Turn on the power supply and observe gas bubbles forming at both electrodes.

2 min
5

Collect gas in the inverted cylinders for 15-20 minutes, recording the volume at each electrode every 5 minutes.

20 min Keep flames away — hydrogen is flammable
6

Compare the volumes of gas collected. The cathode (H₂) should collect twice the volume of the anode (O₂).

3 min
7

Optionally, test the cathode gas with a lit splint (squeaky pop test for H₂) and the anode gas with a glowing splint (relights for O₂).

3 min Use small quantities for gas tests

Resultados esperados

The cathode should collect approximately twice the volume of gas as the anode, confirming the 2:1 ratio of H₂ to O₂. If universal indicator is added, the solution near the cathode turns blue/purple (basic) and near the anode turns red/orange (acidic).

Limpieza

Disconnect the power supply. Dispose of the solution down the drain. Rinse and dry the electrodes.

Detalles

Categoría
Electrochemistry
Dificultad
Intermediate (High School)
Duración
40 min
Costo estimado
$15,00
Pasos
7
Materiales
3

Más experimentos

Batería de Limón 20 min Celda de Concentración 45 min Construcción de la Celda de Daniell 45 min Electrólisis del Sulfato de Cobre 50 min Galvanoplastia con Cobre 60 min Medición del Potencial de Celda Voltaica 60 min Métodos de Prevención de la Oxidación 30 min Verificación de la Serie de Actividad 30 min

Frequently Asked Questions

What is the objective of Electrólisis del Agua?
Descomponer el agua en gases hidrógeno y oxígeno mediante electrólisis, y verificar la relación de volumen 2:1 predicha por la estequiometría.
How difficult is Electrólisis del Agua?
This experiment is rated as Intermediate (High School). It takes approximately 40 minutes to complete.
What safety precautions are needed for Electrólisis del Agua?
Key safety precautions include: Hydrogen gas is flammable — no open flames nearby; Do not use excessive voltage (above 12V); Ensure proper ventilation.
What materials are needed for Electrólisis del Agua?
The main materials required are: Distilled water, Sodium sulfate (Na₂SO₄), Universal indicator.
What results should I expect from Electrólisis del Agua?
The cathode should collect approximately twice the volume of gas as the anode, confirming the 2:1 ratio of H₂ to O₂. If universal indicator is added, the solution near the cathode turns blue/purple (basic) and near the anode turns red/orange (acidic).